SBS Polymer Modified Fiberglass Sheet, for low-angled roofs (15-10 degrees) Mida Self - Sand
Used as a waterproofing material covering the bottom surface, it has high flexibility, durability and can be easily installed over any flat surfaces since it is self-adhesive.
Made from fiberglass, compressed into 2 mm thin sheets, with a mixture of raw asphalt and coated with a special solution on both sides. Provides durability, toughness, repels moisture, and waterproof.
Clean the surface where the fiberglass sheet (OmniSeal 420) is to be installed. Place the sheets in to the desired position. Peel the sticker under the sheet so that the adhesive sheet touches the surface where the installation is made. After verifying the integrity of the installation, use a 35 kg steel roller to roll over 2-3 times to ensure that the cap sheet (OmniSeal 420) is installed according to the specified standards, and which can be applied to be a variety of waterproofing applications.
Weight: 36 kg./Roll
Covers an area of 18 sq.m/Roll
Oriented Strand Board (OSB)
Strong, highly durable throughout its lifespan. Resistant to all types of weather and can be used in both tropical and cold regions.
Our OSB is produced from scraping quality pine wood into small thin crescents, and compressed into multiple layers with the use of wax and resin for adhesion. It is does not warp easily making it highly resistant to moisture compared to conventional plywood.
The most common uses are as wall sheathings, flooring, and roof decking. It is highly flexible and can easily bend to conform to any structure as required.
122 x 244 cm. x 9 mm.
Weight: 20 kg / sheet
100 sheets/bundle (2,000 kg)
Eaves waterproof sheet (STARTER)
To prevent water flowing back under the shingle roof.
Produced from PVC coated with asphalt. It is tough, flexible, strong, and waterproof.
Installed over the water partition, in order to align the boundary before laying the shingle roof, by installing 2 cm beyond the partition.
18 x 1000 cm x 3 mm / roll Weight: 1.8 kg / Roll
To be used to cover surfaces that does not want to be exposed to water. It helps to ventilate moisture.
Is a waterproof paper that repels moisture, coated with a protective coating that does not accumulate moisture.
To be used to cover the OSB plywood layer before installing a shingle roof. It requires a minimum slope of 15 degrees or more.
100 x 3600 cm / 15 pound roll
Weight: 25 kg / roll
Covers an area of 36 sq.m / roll
Metal Drift Edge (Water Blocking Metal Square)
To be used to prevent water from entering under the shingle roof, and protect the OSB plywood for the extension of its lifespan.
Produced from aluzinc coated sheets, a high-quality cold rolled steel, which is not only strong, but also rust resistant and durable.
To be installed over the felt paper and eaves, to prevent rainwater from staining on the eave wood surface.